I think I have followed the tutorial instructions in setting up table of contents (TOC) . When I try to generate the TOC nothing happens. When I then go back and check the settings, I notice that the "Destination Frame" under the "Document Settings => Table of contents and Indexes" has "none" set as its value. I have given a line later on the TOC attribute (so this part appears to work fine).
I have tried a number of times but the value (in my case "TOC1") does not stay there.
Not sure what I might be doing wrong?
I am using the AppImage (Scribus Version 1.4.6)
[attachment deleted by admin]
hi abasel
thanks for having uploaded the document! it helped sorting out what is happening...
i had to add the target frame in the "document settings > toc" and, then, it did work...
ciao
a.l.e
Thanks for taking a look.
I was doing that but the setting (target frame) was not being saved.
It turned out that before the setting would take, I first need to click on "Table of Contents1" (point 1 on attached image) and then set the destination (point 2).
Initially I was going straight to 2 without selecting 1.
[attachment deleted by admin]
eh eh eh
personally, i would not use the automatic table of contents, but type it / copy paste it from the pdf... and setting the page numbers manually...
imo, it's really too much work to create all the attributes and it's not that flexible either.
a style based TOC is coming...
ciao
a.l.e
Thanks again :D