Scribus > PDF Generation

I cannot export to PDF

(1/2) > >>

babochina:
Hi all,
I used Scribus a couple of months ago without trouble.

I had to make a few modifications on a former Scribus file and I noticed I cannot export any .sla files to PDF AT ALL (even the most basic type of document). I just get an error message saying Scribus cannot write the file.

I installed and uninstalled Scribus several times to no avail.

If anyone had an idea, I would be very grateful

Babo

a.l.e:
where are you trying to export to?

is the volume full?

have you write rights to it?

is there any non ascii or space in the path leading to it?

... just trying to guess...

ciao
a.l.e

babochina:
I am trying to save my .sla into pdf,
the volume is not full, it s an original .sla I made myself  ...

and still the same answer "cannot write this file"

thank you for trying to help!

Nermander:
I have seen this issue before and if I recall correct it is a matter of "path problems".

Try saving the PDF to another location on the disk.

babochina:

--- Quote from: Nermander on September 25, 2011, 05:21:51 pm ---I have seen this issue before and if I recall correct it is a matter of "path problems".

Try saving the PDF to another location on the disk.

--- End quote ---
That was it! I saved it straight on my C:\ disk ... and it finally worked!
Lost hours on a small glitch  :( I would have never guessed without your help

A HUGE thank you  ;)

Navigation

[0] Message Index

[#] Next page

Go to full version