Scribusoid

Author Topic: New to Scribus, problems printing simple box.  (Read 1337 times)

testingwithfire

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
  • Scribus User
New to Scribus, problems printing simple box.
« on: October 06, 2013, 08:00:56 pm »
Hi all,

I'm new to Scribus and thought I would try it for printing some frames for comix.

I am running Scribus on Ubuntu 13.04 and am printing to a Canon PIXMA MP480 inkjet.

The attached SLA file is a rectangle with two lines above the bottom margin.

The shapes are grouped.

I've tried:

* Printing the image directly from Scribus. The vertical lines on each side of the box don't print.
* Exporting to PDF 1.3 and printing from Document Viewer. I get the vertical lines but the horizontal lines at the bottom (including the bottom of the rectangle) stop short of the right-hand vertical line.

I would prefer to use an open-source tool to generate my frames. Have tried several tools but the UX on each of them was atrocious. Scribus has a much better UX but if my printing results are no good, I might as well go with another program.

Any advice? Should I file a bug?

Thanks.

Nermander

  • Hero Member
  • *****
  • Posts: 1311
  • Karma: 17
Re: New to Scribus, problems printing simple box.
« Reply #1 on: October 07, 2013, 08:08:52 am »
If the PDF does not print as shown on screen, it's not the fault of Scribus. It's more likely a problem with the printer driver and printer margins.

 

palmate